Diamond Finish - 2 Pack GLOSS Clearcoat System (2K Urethane) 220mlZero Paints Semi-Gloss (Satin) - 2 Pack Clearcoat 220ml (2K Urethane)
- 1 x 100ml Diamond Finish Clear Coat (High Solid) also known as Urethane or Polyurethane ()
- 1 x 60ml Hardener
- 1 x 60ml Thinners
- Instructions
Mixing Ratio
100 Parts Clear + 25 Parts Hardener + 30 Parts Thinner.
(e.g. 50ml Clear, 12.5ml Clear + 15ml Thinners)
Drying Times : Air Drying at 20°C, Dust Free 30 Mins, Tack Free : 10-12 Hours, Thoroughly Dry : 24 Hours.
Is it possible to pre-mix your 2 pack gloss clearcoat then keep it in a jar for later use if not all used in one go, or is it a case of just mixing enough to do the job?
NO YOU MUST NOT DO THIS, once you mix the clear coat and hardener a chemical reaction is started, similar to epoxy glue or epoxy putty. It will hardened within 15/20 mins, if you mixed the lot you would be wasting product and money, so only mix what you need each time, you will quickly find the amounts you need with a small amount of practice.
We would recommend starting with 10ml/gram or Clearcoat - 5ml/gram Hardener and 3ml of Thinners and see how much coverage you get wer fin this is plenty to clearcoat a 1:24 model with 3/4 coats.
Is this safe over decals
Yes, 2K Clearcoat is safe over decals, it has been tested on all the major brands : Tamiya, Fujimi, Aoshima, Studio 27, Cartograf, Scale Motorsport MFH, etc. Please remember to apply a few mist coats over the decals before the wet coats.
It has NOT been tested on homemade inkjet printed decals as so many brands exist, so please test on scrap first.
Is this safe over other paints
Yes, 2K Clearcoat is safe over most other paints (acrylic paint, Tamiya TS) once they are fully dry so please test on scrap first.
What do I clean my Airbrush and equipment with after use
For further information on using Zero Paints and FAQs click here
Basic Zero Paints F.A.Q.
All Zero Paints dry matt and require clear coating unless otherwise specified
Application Notes : Zero Paints are pre-thinned for Airbrush use. Shake container until paint is thoroughly mixed. Spray at 15 - 40 psi, 3 - 4 medium cross coats are recommended. Air drying at 20°C Dust-free: 5 – 10 mins, Tack-free: 20 - 30 mins. For additional thinning use Basecoat Thinners.
Which Airbrush Cleaner should I use ? You can use either use Zero Paints Airbrush Cleaner or Basecoat Thinners, alternatively any thinners that contain Toluene should work, but it's best to test first. DO NOT not use White Spirt or Acrylic Thinners, they are not suitable.
|
Please Note: We can only ship paint to a select list of Countries due to restrictions on the Transportation of Flammable Products. Please click here for a complete list and explanation.
|
|
Health and Safety Notes : |
Use in a well ventilated area. Avoid contact with eyes. Harmful if swallowed, call a Doctor immediately. Keep out of reach of children. Keep away from sources of ignition. Please download the Material Safety Datasheets here -> |